Build your own blaster mod help

JJCOOLX

New Member
I recently brought a Hasbro Build your own Blaster rifle for my girlfriend's costume. It looks great but unfortunatley after 1 - 10 shots (depending on if you have the magazine in) a goofy sounding explosion goes off which I would like to remove. Also the accent led along the barrel only say lit for a few shots before being turned off and I would love for them to always stay on as long as I have the power switch on. Any electronics gurus out there that can possibly help me out?

$_57 (2).JPG20150223_231123.jpg20150313_194640.jpg20150313_194559.jpg
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top