Blade Runner PKD resin blaster (WIP)

Well, it's been a few months since I've had any free time to work on personal projects, but that's because I got a new job, so I'm not going to complain. Anyway, I was finally able to put that new coat on the grip, to finish off my paint.

IMG_1609.JPG IMG_1612.JPG

Now it finally gets its rightful place on my shelf.

FullSizeRender.jpg

Now to spend Labor day how any good American should: starting my next project, a Dredd Lawgiver I picked up in the Junkyard...
 
Looking good for sure. Another trick you can use on a chrome base is a Charpie. You'll have to experiment with colours to make sure you can achieve that amber look...maybe next time;)
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top