Alkaline Trio Christmas Ornament 3D Printed

Thread starter Graphic Jordan
Start date Dec 28, 2010

Graphic Jordan

Sr Member

RPF PREMIUM MEMBER

Dec 28, 2010

Hey guys,

So I had friend/RPF member ROBO3687 model the Alkaline Trio logo... aka the heard with the skull on it.

He whipped up the 3d model in no time. Thanks again for your speed Paul.

I then uploaded to Shapeways and had it printed on the white plastic option.

It turned out great. Attached is a picture.

Thanks again Paul.

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.