Aliens Moton tracker

[propmainiac]

Bought a motion tracker kit 3d printed. Its a good base but some of the parts have been printed together almost giving it a vacuformed look. Im adding some real parts so it looks a little better. Sadly no original parts but close. I came across a Youtube video where they placed a small mp3 player inside the hama viewer that played a video of the motion tracker screen. I tried the same and heres how it looks

 

[starbuckcylon]

Nice work!

 

[propmainiac]

The sound does go louder.. of course i cant leave it alone... Im working on a way i can just quickly drop it in and take it out. The viewer im using is not accurate and requires two hands to open up. I made a holder out of styrene and felt for the player. I cut a hole in the top so i can slide the player in. This will be coverd buy a peice of sheetmetal and the part from the vivitar flash. I will attempt to place rare earth magnets inside the viewer that will hold the sheet metal on therefore allowing me to remove the player.

 

[Paul H Edd]

Screen looks good. Better than a static print. I recall a rasbebby pi with the motion tracker software loaded on outputting to a very old phone screen being used to great effect. I guess you have to be pretty electronics minded. I'll try and find the article. It was a few years back mind. I ordered a motion tracker and 1/32 dropship from The Replica Forge 2+ years ago. Never arrived, stopped replying to messages sadly got ripped off.