Advice on "straightening my sword's edge"

AgentZero

New Member
Hello! I just finished up this master sword for a friend. I'm mostly happy with it, but I couldn't seem to get my blade's edge perfectly straight or even with my dremel. Any advice for future builds?
 

Attachments

  • 20230706_212028.jpg
    20230706_212028.jpg
    2.7 MB · Views: 61
  • 20230706_212120.jpg
    20230706_212120.jpg
    2.8 MB · Views: 60
  • 20230706_212142.jpg
    20230706_212142.jpg
    1 MB · Views: 57
  • 20230706_212142.jpg
    20230706_212142.jpg
    1 MB · Views: 53
  • 20230706_212127.jpg
    20230706_212127.jpg
    1.4 MB · Views: 64
You probably should use a table router to get perfectly beveled edges.
Do it on both sides to get that uniformed edging.

 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top