3D Printed Stormbreaker - FINISHED

Thread starter Magnavis
Start date Jan 23, 2019

Magnavis

Sr Member

Aug 6, 2019

Wicksydude said:
What settings did you use i started with 0.2 then was like the only bit that needs to be 0.2 is the engraved txt so i started printing 0.2 just for the layers with the txt then back to 0.3 for the remainder but it took 20hours still AMAZING file thank you.

I printed at .2 for all of it. Yeah, it's a long print - varies based on how much infill you gave it. My longest print on this project was around 16-17 hours, and that was the top piece of the handle...with 0% infill

(yay...supports -_- )

Print looks clean! Very barney the dinosaur!

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.