3D printed Zeus Thunderbolt from Thor: Lover and Thunder

soswow

Well-Known Member
My first model done in Blender (normally I use Fusion 360). Simple, small (in terms of complexity) design.



Should be pretty close to one on the movie (well one of them - there were a couple of versions - there s much longer one in some scenes).
Screen Shot 2022-09-25 at 10.52.35 am.jpg

vlcsnap-2022-09-25-16h06m19s703.png


My progress with a physical prop so far:

PXL_20220929_121741093.jpg

PXL_20220929_122123770.jpg

PXL_20220929_230600793.jpg

PXL_20220929_234734332.jpg

PXL_20220930_081244953.jpg

PXL_20220930_122709371.jpg

PXL_20221001_042735097.jpg

PXL_20221001_104212434.jpg


Free Files are over here Zeus Thunderbolt from Thor: love and thunder
 

soswow

Well-Known Member
It's not perfect, but close good enough.




 

soswow

Well-Known Member
I might need help, folks.
Not sure how to protect this gold I am using. Super fragile. I was hoping Alclad Klear Kote will do it (Since it works even with Molotow chrome), but it didn't I tried two other acrylic clear coats (just in case) and neither of them do it.

 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top