Limited Run 2nd Run "RUN CLOSED"

Re: 2nd Run Obi ANH Crystal chamber ( Now Taking Payments ) RUN CLOSED

Got mine! :cool Thanks again!
 
Re: 2nd Run Obi ANH Crystal chamber ( Now Taking Payments ) RUN CLOSED

As per PM I'd be interested Rudy,

whats ts the name of the Facebook group? I'd like to join if it's easier for updates and all....
 
Re: 2nd Run Obi ANH Crystal chamber ( Now Taking Payments ) RUN CLOSED

As per PM I'd be interested Rudy,

whats ts the name of the Facebook group? I'd like to join if it's easier for updates and all....

Its the Thin-Neck Saber Fans - https://www.facebook.com/groups/1630255990608776/ there are a few posts in relation to chassis being developed for a FX install with Rudy's chamber kit...
 
Re: 2nd Run Obi ANH Crystal chamber ( Now Taking Payments ) RUN CLOSED

I am already on the interest list that is on "the Facebook".
 
Re: 2nd Run Obi ANH Crystal chamber ( Now Taking Payments ) RUN CLOSED

Hi,

I will post another interest thread on here to see if I can guage more interest. Thanks
 
Re: 2nd Run Obi ANH Crystal chamber ( Now Taking Payments ) RUN CLOSED

Hi. I received mine. Look perfect. Thanks a lot.

Envoyé de mon PLK-L01 en utilisant Tapatalk
 
Re: 2nd Run Obi ANH Crystal chamber ( Now Taking Payments ) RUN CLOSED

Edges softened and machine marks cleaned on convolute wheel. Single pass of base weathering (automatic dishwasher cycle with powdered detergent - aluminum main body/ring and clamp spacer only)

Rudy_MK1_Chamber.jpg

Rudy_MK1_Chamber-2.jpg


Test fitting on FX MK1:

Roman_MK1-3.jpg
 
Re: 2nd Run Obi ANH Crystal chamber ( Now Taking Payments ) RUN CLOSED

Spirit of ob1
I am very happy with this chamber. It complete perfectly the MK1.
What do you think of making a similar chamber for the Soloshold V2?
The lower part will reveal the chamber.
I would love to have a high end chamber for the V2.

Envoyé de mon PLK-L01 en utilisant Tapatalk
 
Last edited by a moderator:
Re: 2nd Run Obi ANH Crystal chamber ( Now Taking Payments ) RUN CLOSED

it looks like you have a weathered FX? i do as well. thanks for the thoughts on weathering the chamber - i am going to do the same thing in the DW. that last picture just looks too perfect even w/o the crystal lit up.

Edges softened and machine marks cleaned on convolute wheel. Single pass of base weathering (automatic dishwasher cycle with powdered detergent - aluminum main body/ring and clamp spacer only)

http://battzero.com/images/propsabers/Rudy_MK1_Chamber.jpg
http://battzero.com/images/propsabers/Rudy_MK1_Chamber-2.jpg

Test fitting on FX MK1:

http://battzero.com/images/propsabers/Roman_MK1-3.jpg
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top