1m long Omega Class Destroyer from Babylon 5

Hi Bob, yes I can see the images on this thread, I was curious if the ones posted on Facebook were different? If they are the same, then no worries.
 
Printed a friend for the Omega :D

30.jpg
 
Nice! BTW, there's a rare example of printing something where the texture created by the FDM printing process actually enhances and improves the appearance of the print! :)

It kinda does actually. Although given the thinness of the spines, and odd angles etc, was a real test of retraction settings, and I did have to do a bit of sanding to clean it up. It will still need to be painted though as there are a couple of seams that need filling.
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top