1:18 Airwolf Model
- Thread starter yt
- Start date
drusselmeyer
Master Member
Thanks for the video. I didn't even know about this kit.
As bad as it looks, I still want one.
A few pointers:
-You can clean up resin without using acetone. Avoid acetone. You can use 99% isopropyl alcohol to clean up resin very easily.
-use a UV light to cure the inside parts if you can reach them. You might even rig up a penlight with a single UV LED to get inside if your curing station does not include one.
-Put all the parts that had resin leaking from them in the sun. It should only take a short time to do this. If they are exposed to strong sunlight for several minutes they should cure pretty quickly. Most small resin parts cure in less than 5 minutes, so judge your parts by thickness from there. If they need more curing, wait longer.
Thanks again for documenting your journey.
As bad as it looks, I still want one.
A few pointers:
-You can clean up resin without using acetone. Avoid acetone. You can use 99% isopropyl alcohol to clean up resin very easily.
-use a UV light to cure the inside parts if you can reach them. You might even rig up a penlight with a single UV LED to get inside if your curing station does not include one.
-Put all the parts that had resin leaking from them in the sun. It should only take a short time to do this. If they are exposed to strong sunlight for several minutes they should cure pretty quickly. Most small resin parts cure in less than 5 minutes, so judge your parts by thickness from there. If they need more curing, wait longer.
Thanks again for documenting your journey.
