Star Trek Voyager EMH Build

Jolijar

Jolijar

New Member
I started working on my EMH Mobile Emitter. I 3d modeled it from an image I found on the internet and printed it out on my 3d printer.
I am wondering what paint I should use to cover it.

Instead of velcro like the screen versions I am using 2 magnets to hold it onto the sleeve.

20160918_201107[1].jpg
 
Last edited:
Jolijar said:
I started working on my EMH badge. I 3d modeled it from an image I found on the internet and printed it out on my 3d printer.
I am wondering what paint I should use to cover it.

Instead of velcro like the screen versions I am using 2 magnets to hold it onto the sleeve.

View attachment 665239
Click to expand...

FYI: The object is called a "Mobile Emitter".
 
Last edited by a moderator:
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Corellianexports
Star Trek TOS Phaser Build
Replies
11
Views
389
AJK001
A
Tripper
Star Trek Voyager Compression Phaser Rifle
Replies
14
Views
1,679
Zombie Killer
Zombie Killer
Tripper
Star Trek TOS Fiberglass Midgrade Phaser Build
Replies
11
Views
1,390
warpsled
warpsled
Jastor00
Star Trek: TNG MkVII Science Tricorder Build
2
Replies
24
Views
2,369
Jastor00
Jastor00
A
Completed: Star Trek Voyager Type 2 Boomerang Phaser
Replies
2
Views
1,278
Alyosius
A
Back
Top