macropod80
Active Member
Whipped up a quick prototype at work today (I'm learning Solidworks - might as well learn on something sensible!):
Not sure about the dimensions yet, will try a few variations before I commit to milling a chunk of aluminium. I've got it half inch thick by 7/8" at widest and 2 1/4" long. I'm assuming as it was made in the UK in the 1960s it's not metric. Looks a bit short, perhaps.
What's the etiquette here - am I hijacking someone else's thread?
Not sure about the dimensions yet, will try a few variations before I commit to milling a chunk of aluminium. I've got it half inch thick by 7/8" at widest and 2 1/4" long. I'm assuming as it was made in the UK in the 1960s it's not metric. Looks a bit short, perhaps.
What's the etiquette here - am I hijacking someone else's thread?