anamorphicWayne
Sr Member
Wow, you made it !!!!!!!
It is looking good. Would like to see movie later. ;-)
Please make sure center pin of cam is better to be supported by upper leg cover. It is meaning another end of center pin that one-end fixed by epoxy but another is not. Some sort of support required. Upper leg cover can have such small digged hole because outside surface have mold.
This is what I have done with my prototype. I assume that you have made but just in case.
I'm well ahead of ya swmodelfan1977. The upper leg covers have a round hole to accommodate the center pin as well as the two channels to support the Pistons. And they lay nice and flush against the legs. I'm not using flat head screws to lock them down, so hopefully the set screws I'm using will work.
Yes! Success all the way!
"Qapla'!" Thanks, joberg.