Turns out there is more fitting and grinding involved, I happen to have three different schwinn fenders that seem correct, and it looks like the skirts will need some sort of notching for clearance, So if you have a grinder you should be able to fit them. Part of the issue is the tire area, the other part is the brake arm on the left side. Then you'll also will need to drill the holes for mounting.
On the spinner discs, I'm going to have to punch the hole a bit larger at work to make them spin properly.
The spot welding burned through on some, leaving some tiny .125" or smaller holes, they can easily be filled with some filler.
I'm fitting a set today so, I'll post some pics later.
Here are an initial fitment, We added a "L" shaped panel on each edge of the skirt, the only thing is that we didn't have great images to see where they start and ended. So I had to do some notching and cutting. I'll make a drawing for the people that purchase them so they have an idea where to cut.
Also you can see on the left hand skirt, if it were to be cut down from the top a bit less material will need to be cut on the bottom. Also past about the 90 degree mark on the fender you won't be able to see because the saddle bags.
I'll PM you if you asked about them. For a shipping cost and total.