My first 'official' saber build on RPF… Luke ANH saber

Great job! Building up a real was one of my first props. You can loose the reflective tape, I recall a while back we decided it was never there on the hero.

True enough. I debated about leaving the GRAFLEX visible, but in the end decided against it. The only closeups I could find very fairly blurry, and looked like no tape, but no 'GRAFLEX' either.
 
Hey, great job! I never had to deal with finding replacement parts, I was spoiled. Great job, very resourceful. the weathering looks epic as well!

The blast-tech glue may fade after a few months, I would just be aware and get some harder glue ready just in case. A couple of my grips are slipping now, still, the best affordable grips out there, so save them!
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top