There is definitely a central rivet in both areas.
Sent from my iPhone using Tapatalk
The other darker style hose that connects to the bellows I got from this etsy seller. https://www.etsy.com/listing/233274...ber-hose-tube-50-60cm?ref=shop_home_active_23 Hope this helps!
eriksmask said:Do you plan on making the oval cross bar as well for this medal?
View attachment 500634
I got a deal on two child-sized gas masks similar to what you've pointed out, Erik. Found a guy with a couple on eBay for cheap... only problem is that he's somewhere in Europe, and I didn't realize that when I finalized my order with him, so now I get to wait until late July or mid-August until they arrive. Damn you, international shipping!
Sure do. Interestingly, I think the way it's presented there is wrong. In the film, the medallion ribbon feeds into the slot:
http://i.imgur.com/KgnHHbe.jpg
I will probably opt to do that.
@Sinned, when you mention the valve, what are you referring to specifically? The connector between the hoses and the mask? I'd love to see what you've got, if that's the case - I've been tinkering with my own model for it but without the hoses to size it properly, I'm kinda shooting in the dark here.
Sinned said:@Ein, sorry, yes, the connector between hose and mask. Happy to send you the .stl file. It's tailored a little more towards my needs...retrofitting a sculpt I did back in October, and added the valves on later, so they have an extension on the bottom, so I can insert them into a hole drilled in the mask. But that's easily chopped off. Or kept, if it helps.
Slightly different than the model you show at the start of the thread, but pretty close. I'm adding the tubing, and screws after the fact, so they're not part of the model. These clean up pretty good with some XTC-3D, or other what-have-you for filling in the striations, etc.
View attachment 500650 View attachment 500651