I still have my box: the weight printed on the side is 4.6 lbs
The top dimension is 14 x 17 and it's about 14.5 inches tall.
I agree and while I know the legend is a higher end helmet, I think this pcr looks nearly as good!Fantastic work. Really looks 100% better.
I agree and while I know the legend is a higher end helmet, I think this pcr looks nearly as good!
Thank you man I appreciate it,
What he said ⬆Heck yeah...These are great...
C'mon Gino...How about a PCR X-wing pilot?!? Maybe even a PCR Fett for good measure???
Jason
The back of the mask at the bottom corners is where it is most flimsy, or "uncomfortably flexible" I'd say. These corners can flex about 1cm without much force. That said, I haven't heard of any that have cracked unless dropped (and some survived drops). The amount of flex and creaking can vary depending on how well the metal stud caps that affix the tubes to the mask were installed. But as long as you're reasonably careful with it, I wouldn't consider this too much of an issue. The back edge of the mask is 2mm thick.I think it looks much better. That is a great looking helmet. I am curious how thin it is. I keep hearing about it being thin, but is it flimsy?
Since we're throwing out suggestions for the next helmet to be released, here's a crazy idea:
How about shipping the ***ing Scout Trooper helmets??????
What he said! ^^
What he said about what he said!!!!!!!!!!!
- - - Updated - - -
While we are at it what the heck happened to the Boba Fett Helmet. The day it was introduced, or shortly there after, we see Gino casting the original helmet. It's a simple helmet to make, no moving parts so whatever happened??
- - - Updated - - -
Or the 1/1 Stormy and Legend Stormy helmet?????