Re: Darkside501st's Iron Man Mk VII pepakura files - New Image pg 124!
Great job on everything guys! I am seeing better and better end results from lots of you. It is very rewarding to see my files being built and finished with such great results.
It is done. Check the link now.
Well, heads are not circles so while 197mm may be the diameter of a 62cm circle, the width of his head will probably be smaller.
Great job on everything guys! I am seeing better and better end results from lots of you. It is very rewarding to see my files being built and finished with such great results.
Dear Dark side,
Is it possible to get a helmet lay out in letter with a scale of 88, or is there a way to adjust so I can print in A4 format to letter settings?
This would be much appreciated.
It is done. Check the link now.
Make sure you have Pepakura Designer. Then find the Diameter of your head in mm(not the circumference), which should be 197mm. Then open the tester helmet and click on 2D Menu, then Change Scale, then Scale Factor. Then put the diameter of your head in the "Width" option. This will give you the scale, which should be 1.03. Build the tester helmet to make sure it's the right size, then download the MK VII helmet in that scale. I'd hate to offend you here, but are you sure that's your head's circumference? 1.03 is a pretty big scale, but that is the right scale for 62cm.
Well, heads are not circles so while 197mm may be the diameter of a 62cm circle, the width of his head will probably be smaller.