Creating Ultron using Iron Man Pep Files

vindicator

vindicator

Active Member
Hey all,

Just want to give a shout out to all you amazing costumers on this site. Without you I would still be in my garage trying to make this out of a duct tape dummy and some plastic blinds. I want to thank Stealth for the amazing plans, and Xrobot and docholiday78 for their sealing techniques.

My Idea was "What If Hank Pym created the Ultron robot out of used Iron Man armors.

First step...The Head



IMG_20110811_180407.jpg
 
Last edited:
Remember, this is before I knew I could do this in foam.

So i went online and found a cheap helmet from Iron Man 2. Glued it together and cut out the creepy smile Utron has. Then made it alot stronger with Bondo and fiberglass

IMG_20120702_212959.jpg
 
So I could not decide on what size foam to buy, 1/2 or 1/4 inch anti fatigue mats.

So I used both, Thank you Sears for the 50% off sale on 1/2 inch matts.

First attempt at the shoulder pads. Not too bad, but could use some work.

IMG_20120620_071314.jpg
 
How did you attach the ear posts to your helmet? Did you use a found object for the cylinders where the metal post attaches?

Nick
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Marthony
Iron Man 2020 helmet pepakura file?
Replies
0
Views
259
Marthony
Marthony
blewis17
VIDEO: "Functioning" Iron man helmet
Replies
1
Views
1,119
signeddiamond
signeddiamond
Jake Kassnoff
Iron man Mk1 Mask
Replies
1
Views
1,232
bobatrek
bobatrek
B
Purchase of Spider-Man Costume
Replies
0
Views
100
BelindaW
B
Cbstudios
Mark 1 Iron Man helmet replica
Replies
1
Views
1,046
Cbstudios
Cbstudios
Back
Top