Using Fusion 360 to create models for Foam Unfolds

SchubroProductions

SchubroProductions

Sr Member
RPF PREMIUM MEMBER
Has anyone here used Fusion 360 to create their 3d Models to bring into Pepakura Designer? If so, was the process the same for creating the unfold for foam. I am wanting to create a foam helmet from scratch but the normal patterning method ala Evil Ted will not work for the base shape.
 
Have exported fusion 360 models into obj format for import into Pepakura, but only simple geometrical shapes not helmets. There are many downloadable base shapes including helmets from Pepakura. I saw a tutorial on youtube creating a Halo helmet for example.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

helix_3
How will expanding foam fill this hypothetical mold?
Replies
4
Views
646
helix_3
helix_3
M
Good acrylic metal paints for Eva foam?
Replies
1
Views
868
Riceball
Riceball
Palantirion
Aliens Brown Bess using Tamiya acrylics
Replies
9
Views
945
septic
septic
PetePolyakov
Looking for someone to build 1:1 Tars for me
Replies
0
Views
324
PetePolyakov
PetePolyakov
helix_3
Primer and mild hard coat for XPS foam?
Replies
0
Views
735
helix_3
helix_3
Back
Top