ERen89
Active Member
I am working on a prop at the moment and cannot determine how I want to go about this one piece. I would have to make sure the lines are absolutely straight. I am trying to avoid EVA foam. I am working with more rigid materials. I considered using sculpey and casting from that, i tried wood burning on some scrap but was not thrilled with the results, I am looking into etching metal. I can't determine which route would be the best. Unless anyone has alternative ideas? I can carve these straight lines into a material easily but it is worrying about making them as clean, even, and straight as possible. I do not want it to look like it was hand drawn. I drew up a template already for the design. Just looking on the approach.