Hello again,
Not entirely sure where I was going to put this question, but since I'm attempting to use it for a Star Wars costume - I was hoping someone might shed some light on what this part may be called.
For the best way to describe this, imagine a pool cue (stick) that separates into two pieces. Normally these are done with a threaded screw on one end and then you just screw the base into it. What I'm looking for is similar, but I need it to be a quick half to three quarters single turn to unlock and lock the pieces together. Some machined metal coupler that would allow that to work. I'm assuming coupler is the right word, but I haven't found luck in actually hunting down such an item. It should be sturdy enough that it requires me to unlatch the two pieces and then latch them again. I just know I don't want some long screwing process to attach the two pieces.
If anyone has any ideas on this, please let me know. Thanks!
Not entirely sure where I was going to put this question, but since I'm attempting to use it for a Star Wars costume - I was hoping someone might shed some light on what this part may be called.
For the best way to describe this, imagine a pool cue (stick) that separates into two pieces. Normally these are done with a threaded screw on one end and then you just screw the base into it. What I'm looking for is similar, but I need it to be a quick half to three quarters single turn to unlock and lock the pieces together. Some machined metal coupler that would allow that to work. I'm assuming coupler is the right word, but I haven't found luck in actually hunting down such an item. It should be sturdy enough that it requires me to unlatch the two pieces and then latch them again. I just know I don't want some long screwing process to attach the two pieces.
If anyone has any ideas on this, please let me know. Thanks!