Jabba guard blaster - anyone have side templates?

Sluis Van Shipyards

Sluis Van Shipyards

Legendary Member
RPF PREMIUM MEMBER
Does anyone have accurate templates for the metal side pieces that attach to the Jabba guard blaster? I figured I should check before I try to figure this out. :)
 
Bammmmmm

SidePlates.jpg
 
Cool pic.
Wasn't there a debate some time ago about whether these were made from some type of surgical scissors?
I think it had something to do with that "bump" at the end of the larger piece. . . darn memory's starting to go.
 
I have resin castings of those side pieces...PM me, with your address, I'll send some to you...[/b]
Click to expand...

Thanks for the offer, but I think I'm going to try and cut these out of aluminum or something.

Thanks David.
 
Thanks for the offer Korbanth. Mine just came in. These are pretty cool. Now the toughest thing I need to figure out is how to attach the "scope".
 
Do you have the VD? If so, scan the picture and resize it to 1:1. print, cut out the sideplates > instant template :)

otherwise just google for a good picture of the blaster, lots out there
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

orntar
My Blaster Factory DL-44
Replies
2
Views
130
Halliwax
Halliwax
A
Anyone have a found parts X-Wing/Snowspeeder helmet ?
Replies
9
Views
1,195
Vaderman
Vaderman
Scruffylooking
Greedo Killer blaster
Replies
2
Views
501
chubsANDdoggers
chubsANDdoggers
woodywaverider
Garindan long snoot: Does anyone have reference pictures of right side or know if the snout stitching is on both sides?
Replies
5
Views
651
Sith Lord
Sith Lord
W
Non Specified Blaster
Replies
5
Views
544
publiusr
P
Back
Top