And the spire. The Palomino is missing parts; there should be a third disc on the nose antenna cluster. Same thing happened here, a ring is missing where the lower array of probes terminate in midair. Got to get to the bottom of that.
Again this was too flexible and the final piece will need to be brass tube with the antenna clusters printed as sleeves; that will allow for fibre optics as a bonus. Another problem is that small round items like the "saucer" antennae tend to elongate during printing. I will have to compensate for that on the mesh files.
Still that's what these protos are for, and it is fun to see how it will look. Incidentally the complete tower is about 14" tall.
Again this was too flexible and the final piece will need to be brass tube with the antenna clusters printed as sleeves; that will allow for fibre optics as a bonus. Another problem is that small round items like the "saucer" antennae tend to elongate during printing. I will have to compensate for that on the mesh files.
Still that's what these protos are for, and it is fun to see how it will look. Incidentally the complete tower is about 14" tall.