Re: Where to buy accurate BTTF2 cap?
Sure, will whip it up in a bit...
@Spyhunter2k, the new pattern looks great, but there is one thing I think needs tweaking. I do not thing the sides are actually perfectly vertical. My tweaked pattern had them sloping inwards so the new walls were about 1/4" in at each end (at the point where the triangles begin) making that point of the pattern a full 1/2" narrower than your original pattern. The sloping turned out to be too much, but I do think it's necessary, so could you slope your sides in say 1/8" on each side, making that point 1/4" narrower than the square version?
Sure, will whip it up in a bit...