vistaVision
Sr Member
I'm looking for someone to help me out with designing a very simple pcb for a prop project. I need a quantity (30 or 40) small boards made up. Each board is small, about 1/2 inch square, and carries 3 resistors and a few solder pads for some wires. A switch, 9V battery and 3 LEDs are wired off-board. I want the pcb to just help tidy everything up. I've made several of these from perfboard, soldering little wire jumpers, but that gets old fast... I would like to explore using one of the custom pcb shops; it is possible that might be reasonably cost effective. If not, if I had the artwork properly prepared, I'd make them myself.
I am only barely electronic literate, and don't have the time or desire right now to learn a pcb CAD system. This would be a very simple project for any of you guys that actually know what you're doing. Anybody interested in lending a hand? Thanks for any guidance, advice and/or assistance!
Marcus
I am only barely electronic literate, and don't have the time or desire right now to learn a pcb CAD system. This would be a very simple project for any of you guys that actually know what you're doing. Anybody interested in lending a hand? Thanks for any guidance, advice and/or assistance!
Marcus