division 6
Master Member
There appears to be gaffers tape on the sides.
Possibly it wraps around the back holding the center piece in place.
Possibly it wraps around the back holding the center piece in place.
I think what you might be seeing is left over texture from the print bed when it was 3d Printed and a little bit of glue. The chip is definitely not seated flat or flush within the housing, it's tilted up towards the bottom of the image so that it's almost even with the top of the housing.There appears to be gaffers tape on the sides.
Possibly it wraps around the back holding the center piece in place.
I found a better picture.
Smooth finish with Glue? on the edge.
It looks like it's falling apart and at an angle.
Also notice the space (crack) next to the chain plate.
View attachment 833012
I have a feeling it might be a very pale gold. I haven't seen Solo: a Star Wars story, yet. Any of you got other resource pics?
I’m afraid it apears to be so.... unless one of the sides is thicker than the other.UGH!!! Now I'm looking at that higher rez photo and think it's completely off again LOL.
OK Tell me if I'm crazy. Is the whole thing SUPPOSED to be the same thickness and the chip is just misaligned? are the side bars actually the same thickness as the chip?
In the first photo @thawn_es posted, it looked like it was just a bad crop job, but with the newer clearer image it looks like these parts circled are the same thickness.
View attachment 833046
Which makes me think it's SUPPOSED to look like this (all the same thickness)
View attachment 833047
and the middle chip part just got glued in crooked, making it look like this.
View attachment 833048
UGH!!! Now I'm looking at that higher rez photo and think it's completely off again LOL.
OK Tell me if I'm crazy. Is the whole thing SUPPOSED to be the same thickness and the chip is just misaligned? are the side bars actually the same thickness as the chip?
In the first photo @thawn_es posted, it looked like it was just a bad crop job, but with the newer clearer image it looks like these parts circled are the same thickness.
View attachment 833046
Which makes me think it's SUPPOSED to look like this (all the same thickness)
View attachment 833047
and the middle chip part just got glued in crooked, making it look like this.
View attachment 833048