fortytwo
New Member
Hello,
I am starting to construct a replica ghost in the shell medi pack. I have a lot of images saved of the actual props and hoping to eventually have a pretty accurate replica someday. I am currently on research stage, analyzing the pictures. I currently;y have a good one I worked to remove the aspect ratio that also has a ruler. I can use this one for scale. IT appears the "Vile" is constructed from 1/2 inch OD hose. Two white ends that snap together but not at right angles. some sort of rivet or metal end. the inside of the rivet is visible in the end of one. Total length is 4 inches end of rivet to end of rivet.
The ends appear to have something cut off where the rivet is, almost like a arm or fitting. the tube side is pretty obviously cut short, off of something. one end pics you can see cut lines, not cast lines. A friend is modeling them for 3d printing until I can identify.
The barcode I haven't been able to define. At first I thought it was pharamacode but there appears to be three or four bar widths. for now I am sticking with pharma code. I thought it would equal something cool like 2501 or 2571
The board isn't too precisely cut 4.75 by 7.25 inches rounded ends, looks table saw cut. with a decal (maybe water slide) on back and it appears the HANKA is brighter possible affixed to the front.
I have not explored the bag, think maybe I can use a food saver to seal, just need to find the right material and rivet.
Anyone have any info to lend to the project?
Thanks
I am starting to construct a replica ghost in the shell medi pack. I have a lot of images saved of the actual props and hoping to eventually have a pretty accurate replica someday. I am currently on research stage, analyzing the pictures. I currently;y have a good one I worked to remove the aspect ratio that also has a ruler. I can use this one for scale. IT appears the "Vile" is constructed from 1/2 inch OD hose. Two white ends that snap together but not at right angles. some sort of rivet or metal end. the inside of the rivet is visible in the end of one. Total length is 4 inches end of rivet to end of rivet.
The ends appear to have something cut off where the rivet is, almost like a arm or fitting. the tube side is pretty obviously cut short, off of something. one end pics you can see cut lines, not cast lines. A friend is modeling them for 3d printing until I can identify.
The barcode I haven't been able to define. At first I thought it was pharamacode but there appears to be three or four bar widths. for now I am sticking with pharma code. I thought it would equal something cool like 2501 or 2571
The board isn't too precisely cut 4.75 by 7.25 inches rounded ends, looks table saw cut. with a decal (maybe water slide) on back and it appears the HANKA is brighter possible affixed to the front.
I have not explored the bag, think maybe I can use a food saver to seal, just need to find the right material and rivet.
Anyone have any info to lend to the project?
Thanks