Want to Make my LEDs Flicker!
- Thread starter MythMaker
- Start date
propmaster2000
Sr Member
Hi MythMaker,
Have you tried putting a 9V battery on the two wires (Red positive and black negative) and can you show a picture
of the back side of the boards including the round LED board?
Have you tried putting a 9V battery on the two wires (Red positive and black negative) and can you show a picture
of the back side of the boards including the round LED board?
MythMaker
Active Member
I cut off the converter circuit and connected the battery pack directly to the flicker circuit, switch, and LEDs - SUCCESS! I think I just use this for now, but I'll be back to do a smaller version of the watch using the Arduino/Adafruit/Neopixel stuff. Will post a video to show you guys the watch working with the flickering!
propmaster2000
Sr Member
NICE!
Have you tried your strip of LEDs in place of the original?
Also, can you take a quick video of the working circuit you have now?
Thanks.
propmaster2000
.
Have you tried your strip of LEDs in place of the original?
Also, can you take a quick video of the working circuit you have now?
Thanks.
propmaster2000
.
propmaster2000
Sr Member
Bumpity, bump.
Have you taken a video of your LED setup and will it work with your LED strip?
Here is a short video of my effort to make a wrist LED light using the 8 Neopixel LED ring, Arduino electronics and battery:
One thing about NEOPIXEL Leds, they only require 5vDC.
.
Have you taken a video of your LED setup and will it work with your LED strip?
Here is a short video of my effort to make a wrist LED light using the 8 Neopixel LED ring, Arduino electronics and battery:
One thing about NEOPIXEL Leds, they only require 5vDC.
.
Last edited by a moderator:
