-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Done / Completed VERA KIT, (RUN IS DONE!)
- Thread starter JOATRASH FX
- Start date
ROLL CALL.
Will be taking payments for this very soon. SOUND OFF ASAP if you are in. Please DO NOT message me if you DON'T want one as it clutters up the inbox. Thanks!
Will be taking payments for this very soon. SOUND OFF ASAP if you are in. Please DO NOT message me if you DON'T want one as it clutters up the inbox. Thanks!
OK FOLKS, that's about it.
It's been a long, bumpy ride for this kit but it did get finished in the end. The level of response pretty much signifies that interest in Firefly props is pretty much dead. (Maybe I should have a 'retirement party' with all my other Verse kits and offer them one final time?) After this weekend, I will probably set the status to "DONE" and stop watching it actively.
It's been a long, bumpy ride for this kit but it did get finished in the end. The level of response pretty much signifies that interest in Firefly props is pretty much dead. (Maybe I should have a 'retirement party' with all my other Verse kits and offer them one final time?) After this weekend, I will probably set the status to "DONE" and stop watching it actively.
Are there any pics of the actual cast kit?
Post 198 on page 10 has photos of a casting being assembled.
Oh duh!!!!
macross40k
New Member
Any idea what people have typically used as a "close enough" mount for the PVS-18?
I just made one and printed it. I could do 3d printed copies, but even though they're a small job, with setups and shipping it'd cost more than the PVS-18 replica (probably around $75 shipped).
WOW!!! That looks amazing! Wish the timing was different because that would be enough to get me back into the hobby 
macross40k
New Member
I received mine today and am so excited to get this thing together. Great quality cast that won't take much prep work at all!
Have now set the status of the thread to "done" since all orders are shipped out. I'm sure Morganthirteen is willing to do a few more, since we are nowhere near recouping even the material costs for this, but I don't think the thread will be maintained any longer.
For those that need a mount for the scope, I can 3d print them on demand. Cost will likely be around $75 shipped. Send me a PM if you need one.
For those that need a mount for the scope, I can 3d print them on demand. Cost will likely be around $75 shipped. Send me a PM if you need one.
Similar threads
