Vacuum Forming Sheet Guide

Discussion in 'General Modeling' started by Lukea, Dec 12, 2011.

  1. Lukea

    Lukea New Member

    Trophy Points:
    2
    Hi

    I am building a vacuum forming table and am a bit overwhelmed with all the 'poly' this and 'poly' that names for stuff. I need to order large sheets of the stuff and don't want to order the wrong thing. Is there a guide or place to read up on this? I tried searching the forum but ended up jumping from one thread to the next where words are used interchangeably and inconsistently.

    Thanks
     
  2. KLINGONSNIPER

    KLINGONSNIPER New Member

    Trophy Points:
    16
  3. joewhite

    joewhite Sr Member

    Trophy Points:
    1,046

Share This Page