Vacuum Formed Iron Man Helmet

Thread starter DavidFrommi18
Start date Oct 8, 2011

DavidFrommi18

Well-Known Member

Oct 8, 2011

Hi Guys,

Over the last few months i have built my own vacuum forming machine. My first test was using an iron man helmet. The test worked ok but destroyed the original mould. Advice..... don't use a hollow mould as it crushed my original mould.... Anyways here are a few pics.....

Cheers David

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.