joewhite
Sr Member
I hadn't planned on building this anytime soon. However, I recently took an interest...
Here's something I threw together based off of Frank's instructions. It's all been laser cut/etched.
- The plate is a guide for the lines of symmetry.
- 2nd photo, top part, half circle cutout, is an exact guide so that the lines of symmetry can be drawn on the hemispheres.
- The split circle is made according to Frank's dimensions but I still need to figure out the amount of edge to trim. Once I figure that out, I can have a final drawing that will be ready as soon as it is cut. Then, I'll make an entire set for a Remote.
- Not shown, but I made a bunch of the small rectangles.
While I will be using this for my own build, I am hoping this stuff might be useful in a certain "kit". :love
Off to Plastruct I go... More soon.
Joe
Here's something I threw together based off of Frank's instructions. It's all been laser cut/etched.
- The plate is a guide for the lines of symmetry.
- 2nd photo, top part, half circle cutout, is an exact guide so that the lines of symmetry can be drawn on the hemispheres.
- The split circle is made according to Frank's dimensions but I still need to figure out the amount of edge to trim. Once I figure that out, I can have a final drawing that will be ready as soon as it is cut. Then, I'll make an entire set for a Remote.
- Not shown, but I made a bunch of the small rectangles.
While I will be using this for my own build, I am hoping this stuff might be useful in a certain "kit". :love
Off to Plastruct I go... More soon.
Joe
Last edited: