TNG Cobrahead Phaser


Arky

New Member
I printed this model from Unimatrixred's awesome Cobrahead phaser kit on Thingiverse: Star Trek TNG 'Cobra head' Phaser Kit by UnimatrixRed. It took about a day to print, and another couple of days to fill, sand and paint. I used Krylon Fusion Matte Black and Matte Glacier Gray for the body, and some cheapo craft store acrylics for the buttons/power indicator.
 

Attachments

  • 8.jpg
    8.jpg
    3.3 MB · Views: 71
  • 1.jpg
    1.jpg
    3.8 MB · Views: 36
  • 2.jpg
    2.jpg
    4.7 MB · Views: 34
  • 3.jpg
    3.jpg
    4 MB · Views: 31
  • 4.jpg
    4.jpg
    3.7 MB · Views: 29
  • 5.jpg
    5.jpg
    4.1 MB · Views: 31
  • 6.jpg
    6.jpg
    3.8 MB · Views: 61
  • 9.jpg
    9.jpg
    4 MB · Views: 70

renaissance_man

Sr Member
RPF PREMIUM MEMBER
That's a good replica, nice clean up on the 3d print, nice to not see print lines.

I'm not sure if you were going for a custom paint finish but the original props had the 7173 "Starfleet Silver" for the main body with gold and silver power, beam width and trigger buttons.
Screenshot_20211116-084335.jpg
 
Last edited:

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top