"The Flash" (Barry Allen) Silicone mask/hood

shatteredfx

New Member
"The Flash" Silicone Mask Still a WIP but should be done and molded this week.
Based on the CW's tv show, not the comics.
Sculpted out of monster clay and will be cast out of ecoflex silicone. I made this as a personally project, Won't be selling these through our website or anything. I will definitely be making a few for those interested. Maybe a limited run of 10-15.

Huge fan of the flash so I had to make one. Excited about both the red paint up and the yellow for the reverse flash! Can't wait for season 2 but maybe this will hold me over! Haha

Let me know what you guys think. Still a few hours of sculpting left and I'll upload more final photos then!


Best,
Jarred

okokokoko.jpg
 
Last edited:
This is gonna be awesome! I'm definitely interested and I'll be following the progress eagerly :) I was planning on sculpting a 12" of him and the reverse flash.
 
Ill be posting the reverse flash tonight, but im going to hold off on the regular flash. The paint i used for the bolts is wayyyyy to bring and ruins the mask, i actually found "Flash Yellow" Paint, so im thinking that will be spot on. The rings are metal and the bolts are smooth cast 65d. Mask is platinum silicone, no need for zippers or multi-piece masks.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top