Test Run..Iron Man Face Plate

Thread starter Noc
Start date Sep 10, 2011

Noc

New Member

Sep 10, 2011

I did a post some days ago about using foam or cardboard to do my first helmet. So I picked cardboard because my girlfriend had some laying around at her job(free cardboard). I did a test run by just making the face plate to see how it would come out and how hard it would be to work with the cardboard. I think I did and ok job for a first timer....but yall can tell me how it looks so far.

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.