Terminator T-800 measurement needed.

iowadude41

Active Member
Hello again everyone,
My T-800 is coming along great, but I've run into a snag. I'm hoping someone out there has the measurement I'm needing to continue building or I'll have to guess. I'm using a pic from another user in here just as a reference only.. I've added 3 red lines, 2 horizontal, and 1 vertical. I need the exact measurement of the vertical line from the top of the 5th vertebrae to the bottom of the connection where the arms attach to the center of the chest cavity. I need that in inches so I can mark the location on my center pole so I can get the correct placement of the front and back chest plates. Once I have them mounted, and in place, I can start designing, and building the arms, and all the cool things they attach to.

Thank you to all who have commented on my pics, and project so far, and to all who can help with this problem.
 

Attachments

  • measurements.jpg
    measurements.jpg
    178.6 KB · Views: 104
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top