Pep clone helmet first pep project.

Thread starter JediPete
Start date Mar 30, 2012

JediPete

New Member

Mar 30, 2012

Started this a few weeks ago and thought I'd post some pic here. I have recently found out that I should of had numbers on the print outs so that's something to look into on my next part.

This is just a helmet thread and if it works out it will become a full phase 2 series 3 clone.

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.