Original armour sculpt

Thread starter redhawk591
Start date Mar 20, 2014

redhawk591

New Member

Mar 20, 2014

Hi, so I have made a few pieces over the past couple of years and so I though I should start doing some clay sculpting as it gives you alot of freedom. I only started the sculpt a couple of days ago but I wanted to get some opinions on the direction of the helmet. So if anybody has any advice it would be greatly appreciated

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.