Need help - 3d printingen and casting neckless Batfleck cowl

[Albuin]

Hi everyone!
I've searched a long time for a neckless Batfleck cowl and finally found a free 3d printing file!
So, to whom should I talk if I want this cowl printed and cast in urethane rubber? Or has anyone allready done this cowl?

This is the file: https://www.myminifactory.com/object/batman-cowl-20596

Thanks!

 

[coofunkcurly]

By the time someone printed this and made a mold it would cost much more than just buying one of the cowls out there and trimming away the neck.

 

[drftfan]

Exactly what Kevin said.

 

[Albuin]

Ok, thank you guys. I thought this might be a good way to go.
I've once tried to trim a Batman Begins cowl and the result was not very good, but I've already found a shop which makes just the cowl without the neck.

 

[Vlair]

If you want a neckless cowl with a similar look, why not go with the Arkham Origins cowl? It's sculpted to end at the base of the skull there, where as I feel like cutting the neck of of this cowl will give you a thicker, harder edge sort of look. that would be my concern is all.

 

[Albuin]

If you want a neckless cowl with a similar look, why not go with the Arkham Origins cowl? It's sculpted to end at the base of the skull there, where as I feel like cutting the neck of of this cowl will give you a thicker, harder edge sort of look. that would be my concern is all.

I know what you mean and that's the reason why I don't want to trim away the neck from any cowl. I don't like the Arkham Origins cowl that much. Some years ago I bought a TDK cowl from coofunkcurly and I'm very happy with that one.
Maybe I'm going to you this one or buy the one I found on etsy.

 

[kw1968]

there's a neck-less batfleck cowl on etsy

 

[sp1derman]

just ask tigerstone to cut the neck off for an additional cost

Hi everyone!
I've searched a long time for a neckless Batfleck cowl and finally found a free 3d printing file!
So, to whom should I talk if I want this cowl printed and cast in urethane rubber? Or has anyone allready done this cowl?

This is the file: https://www.myminifactory.com/object/batman-cowl-20596

Thanks!