neca 1;4 hand mods

georgieboy26

New Member
modded some hands for different grip poses altered the jutting out thumb on clenched fist as it looked odd...

P12.jpg


P1010001.JPG


P1010002.JPG
 
cool how I can do the same? hair dryer?

thanks
warm with dryer, cut small v shape under knuckle area, bend and glue....I used superglue.......done.....if you accidentally cut of a finger, just drill small holes in both pieces, slide in a short wire and glue it in and fit bits together......you can virtually get the fingers into any pose you need, hope this helps
 
Heat Gun on low works very well. Better then Hair dryer. Little faster as well. No need to cut figure if use a heat gun....
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top