Mr. Fusion Base

Thread starter Veldmaat
Start date Nov 14, 2021

Veldmaat

Well-Known Member

Nov 14, 2021

I recently found the Krups 223A grinder which Inwanted to turn into a Mr. Fusion replica.
I know I had STL files for the base at some point. But, unfortunately I’m unable to find them.

Does anyone here have the correct STL files for the base?
Or point me in the right direction for the files?

I know there are some on Thingiverse, but those are not correct.
The lid has a recessed area for the grinder instead of a “platform”.

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.