Millennium falcon side panels?

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


nightrider

Sr Member
I'm fixing to start building an mpc falcon. I haven't had any luck getting a response from falcon kits for the side panels, so I'm considering making my own out of styrene. This will be my first attempt at making parts for myself. If anyone has any suggestions I would love to hear them. The first thing I need to know is the proper side panel height. It appears that the rear side panels are about one sixteenth of an inch higher than the front mandible sides. Not sure though.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top