Done / Completed MiB

brandomack

brandomack

Sr Member
i am planning a limited run of these soon, these will be cast in fine pewter, with the vacuum tubes in pressure cast resin.

image.jpegimage.pngimage.jpeg
(3D Model by sauer33)

image.jpegimage.jpeg

image.jpegimage.jpeg



If i can get 10 interested, i can do these for $599 plus shipping.
 
Last edited:
Re: MIB 3 1969 Series 1 Deatomizer (Aluminum)

and if you can't do the vintage gun, I would sell my granny's ashes for a 2012 standard issue sidearm.
 
Last edited:
Re: MIB 3 1969 Series 1 Deatomizer (Aluminum)

Put me down as interested. Look forward to more info and pricing!
 
Re: MIB 3 1969 Series 1 Deatomizer (Aluminum)

Any way we could get this mentioned out in the wider forum? I guess not everyone is looking in the project runs page very often, like me, but if they new the possibilty existed...
 
Re: MIB 3 1969 Series 1 Deatomizer (Aluminum)

I will. I just wasn't sure of the forum etiquette. Don't want to become one of the BANNED group... ;-D
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

gmprops
Limited Run MIB Men in Black Neuralyzer Electronics - Reduced
2
Replies
25
Views
2,533
JohnnyPyro
JohnnyPyro
Zombie Killer
MIB Men In Black Pulsar Blaster
Replies
10
Views
2,247
mbmcfarland
mbmcfarland
rgriesbeck
Done / Completed MIB Noisy Cricket (3D Printed Kit)
2 3
Replies
52
Views
2,912
rgriesbeck
rgriesbeck
Back
Top