Skullopathy
New Member
Some days ago, I was asked if I could make a sniper rifle for a Garrus cosplay. The limit date is 12th of December. Well, the past week I drawed the plans, and the past Monday I started to cut pieces. The rifle it's Ok, so tomorrow I will begin the scope.:cool
Because I'm on a hurry, I did not much photos, but here you have few of them.
At first of all, i must say that this will be a dismountable rifle, so you can see three parts: the barrel, the grip and the back.


The barrel is made from a silicone tube. The gas tube it's from a pvc pipe. The join of the barrels its a HIPS plastic, glued everything with epoxy.


The grip: I would put a trigger, but I haven't space enough, so I don't know if I'll do it finally.



Process of the back sidepieces



The back sidepieces with the mid sidepieces (it's not glued yet)

The front sidepieces. I caged both and cut it with a saw (21'5 degrees)

A preview.

Everything glued! Tomorrow it will be dried and it could be mounted
More pics soon!
Because I'm on a hurry, I did not much photos, but here you have few of them.
At first of all, i must say that this will be a dismountable rifle, so you can see three parts: the barrel, the grip and the back.


The barrel is made from a silicone tube. The gas tube it's from a pvc pipe. The join of the barrels its a HIPS plastic, glued everything with epoxy.


The grip: I would put a trigger, but I haven't space enough, so I don't know if I'll do it finally.



Process of the back sidepieces



The back sidepieces with the mid sidepieces (it's not glued yet)

The front sidepieces. I caged both and cut it with a saw (21'5 degrees)

A preview.

Everything glued! Tomorrow it will be dried and it could be mounted
More pics soon!
Last edited: