Mark ii viper build

BrundelFly

Master Member
RPF PREMIUM MEMBER
The Cockpit.

img0308bc.jpg
 
Thanks!
Posted a few more pics. I went lighter on the weathering than usual. I wanted more of the cleaner look. This model is for WILLIE GOLDMAN! Hope he likes it.
 
Thanks Again everyone good to be building again.

OH how I MISSED the SMELL of GLUE.....

I have clear heads, and have seen great results with them. However,
I used opaque resin. I dremeled out the head, and SLOWLY removed the face, then removed a TINY bit of the forehead of the figures head so the light could peek over the top. I have clear cast face plates, but I might try vacuum formed ones next time.
 
okay... that is awesome on many levels!
Do you have some extras of the clear head part you sell? That takes it to a whole other level of cool!
best,
Ken
 
Can't believe no one said, that's FRAKKING cool. I am thinking about modeling and I see this. Makes me more determined.
 
I have extra clear heads, but like I said, I didn't use one

I used a regular resin one. Just dremeled it out.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top