LED electronics question

GBrittelleJr

Well-Known Member
So, I need to wire up some LEDs in a manner similar to Iron Man eyes, but a solid bar as opposed to two separate eyes. I'm still wanting to see out of it, from under it like Iron Man. The bar is 5.7-6" in length, and I want the LEDs to be the absolute brightest possible.

Could any of you electronic gurus give me a hand? Thanks!

Greg
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top