Jurassic Park Dilophosaurus Lifesize 3D Printed bust......

yankeetrex

Active Member
Hey Everyone,

Im kind of new to the 3D printing game, but i wanted to have a bust made of a Jurassic Park Dilophosaurus. So luckily, Futurescape 3d came to my rescue. I sculpted this in Zbrush and sent them the file to print . Half a week later and here it is......

6eVw5DR.jpg

5msl1jd.jpg

jMClDVm.jpg

WQgwoam.jpg
 

Attachments

  • 5msl1jd.jpg
    5msl1jd.jpg
    168.4 KB · Views: 126
Very cool. I have a bunch of dino skulls i was thinking of making casts of. Just to practice coloring techniques. Id like to see it once you paint it. I assume you plan on doing that?
 
would it be possible to share the 3d file? My next planned build is one of the Jeeps (once I have the $), so this might be a nice diversion to print and paint while I save up.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top