Djstorm100
Active Member
This is my 4th helmet and while part of me wants to give up I must push on! This is sharkmarks helmet and in trying to motorized it but I keep getting the scale wrong. You would figure by the 4th build I would have it right but nope. I've include some pictures and curious if any body could help me in the scale part. I need about another .5-.75inch to comfortable out the servo where I want( experimenting) other options too (chin) I could do it the easy way and use default scale but those helmets are sooo big!
I screwed up on some of the fiberglass as it does not lay flat. I learn alot of lesson an will apply them on the next helmet but I must get scale right this time. Worst case I run cables and put the servos remotely somewhere else.
Can I use rondo instead of fiberglass? If I use a big fiber sheet vs smaller overlapping squares will it be just as strong ?
Here are the pictures, current scale is .965
This is comparing .965 to .97 ( tester?
I screwed up on some of the fiberglass as it does not lay flat. I learn alot of lesson an will apply them on the next helmet but I must get scale right this time. Worst case I run cables and put the servos remotely somewhere else.
Can I use rondo instead of fiberglass? If I use a big fiber sheet vs smaller overlapping squares will it be just as strong ?
Here are the pictures, current scale is .965
This is comparing .965 to .97 ( tester?