How to Thin out Tulip dimensional Puff paint?


Active Member

I would like to know how to thin out Tulip dimensional puff paint/ 3D fabric paint. My idea is to make it very thin, so I can make a wall around the chest spider of my TASM 2 suit and then pour the paint on to the spider to get a smooth surface.

Can I add some water into the paint and shake the bottle?

does anyone have experience?
I am not planning using acrylic paint. I would like to paint the webs with tulip 3d fabric paint and the use the same paint, mix it with water and then fill the spider to get a smooth surface.

Anyone tried this? Or any suggestions
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.